Jeep 2014 Cherokee - User Guide Instrukcja Użytkownika Pobierz pdf (Strona 33)

ENGINE BREAK-IN RECOMMENDATIONS

A long break-in period is not required for the engine and drivetrain (transmission and

axle) in your vehicle.

Drive moderately during the first 300 miles (500 km). After the initial 60 miles

(100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.

While cruising, brief full-throttle acceleration within the limits of local traffic laws

contributes to a good break-in. Wide-open throttle acceleration in low gear can be

detrimental and should be avoided.

The engine oil installed in the engine at the factory is a high-quality energy

conserving type lubricant. Oil changes should be consistent with anticipated climate

conditions under which vehicle operations will occur. For the recommended viscosity

and quality grades, refer to “Maintaining Your Vehicle.”

NOTE:

A new engine may consume some oil during its first few thousand miles (kilometers)

of operation. This should be considered a normal part of the break-in and not

interpreted as an indication of an engine problem or malfunction.

CAUTION!

Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may result.

TURN SIGNAL/HIGH BEAM LEVER

Turn Signals/Lane Change Assist

Tap the lever up or down once and the

turn signal (right or left) will flash three

times and automatically turn off.

Flash To Pass

• Pull the lever toward you to activate

the high beams. The high beams will

remain on until the lever is released.

High Beam Operation

• Push the lever forward to activate the

high beams.

NOTE:

For safe driving, turn off the high beams

when oncoming traffic is present to pre-

vent headlight glare and as a courtesy to

other motorists.

Turn Signal/High Beam Lever

1 — High Beam (Push Forward)

2 — Flash To Pass (Pull Toward Driver)

OPERATING YOUR VEHICLE

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 203 204

Brak uwag

Jeep 2014 Cherokee - User Guide Instrukcja Użytkownika Strona 33